17
Turning Power On/Off
Preparation
(ICP-6520 control panel display. The ICP-6530 also
has an [M/E2] button.)
3
Pull the fader lever down from top to bottom.
When “Non Sync” or “Sync” appears at the top and
bottom stops of the fader lever (non-sync state), the
fader lever movement and transitions do not match.
Pull the fader level from top to bottom to release non-
sync state.
4
Turn on the power of other devices in the system.
Screen saver and panel sleep mode
If no operation is performed for a given time, the menu
display screen saver starts. The brightness of all indicators
and displays on the control panel also dims.
For details about settings, refer to the User’s Guide.
To turn the power off
1
On the menu screen, check that the local disk is not
being accessed.
A “local disk” refers to the internal flash memory drive
in a control panel.
While the system is accessing the local disk or frame
memory external HDD, the indicator on the menu page
number button lights red.
Check to make sure the indicator is not lit before
turning off the power.
Remove all USB flash memory and other removable
disks before turning off the power.
2
Shut down the control panel.
Press the menu page number button and display the top
menu window, then press the [Shutdown] button.
(ICP-6520 control panel display. The ICP-6530 also
has an [M/E2] button.)
Fader lever
Notes
Indicator on the menu page
number button
Menu page
number button
Shutdown button
To Next Page
Loading...
Need help?
General