Sony STR-DG810 User Manual

Remote commander
The remote does not function.
• Point the remote at tile remote sensor on
the receiver.
• Remove any obstacles in the path between
the remote and the receiver.
• Replace all the batteries in the remote with
new ones, if they are weak.
• Make sure you select the correct input on
the remote.
• When you operate a programmed non-
Sony component, the remote may not
function properly depending on the model
and the maker of the component.
Error messages
If there is a malfunction, the display shows a
message. You can check the condition of the
system by the message. Refer to the following
table to solve the problem. If any problem
persists, consult your nearest Sony dealer.
If an error message appears while you perform
Auto Calibration, see "When error codes
appear" (page 32) to solve the problem.
PROTECT
Irregular current is output froln tile receiver.
The receiver will automatically turn offafter
a few seconds. Check the speaker
connection and turn on the power again.
If you are unable to remedy the
problem using the
troubleshooting guide
Clearing the receiver's memory may remedy
the problem (page 27). However, note that all
memorized settings will be reset to their
factory settings and you will have to readjust
all settings on the receiver.
If the problem persist
Consult your nearest Sony dealer. Note that if
sec,.'ice personnel changes some parts during
repair, these parts may be retained.
Reference sections for clearing
the receiver's memory
To clear See
All memorized settings page 27
Customized sound fields page 58
gOus

Sony STR-DG810 Specifications

Audio Specifications

impedance	8 Ohm
channel power rating	110 Watts X 6 (8 Ohms, THD 1.0%)
sound fields	Cinema - 3; Music - 3; Auto Format Decoding - 11; 2 Channel - 1

Power

power requirements	AC 120V, 60 Hz
power consumption (in operation)	TBD
power consumption (in standby)	TBD

Inputs and Outputs

composite video input(s)	4 (1 Front, 3 Rear)
composite video output(s)	1 (Rear)
optical audio input(s)	2 (Rear)
optical audio output(s)	1 (Rear)
coaxial audio digital input(s)	1 (Rear)
RCA audio input(s)	7 (3 Dedicated, 4 Audio/Video)
RCA audio output(s)	2 (1 A/V Output, 1 Output)
subwoofer output(s)	1 (Rear)
antenna terminal (AM loop)	1 (Rear)
antenna terminal (FM 75 Ohm)	1 (Rear)
headphone output(s)	Yes (Front- Silver)
HD component video input(s)	3 (Rear)
HD component video output(s)	1 (Rear)
HDMI™ connection input(s)	3 (Rear)
HDMI™ connection output(s)	1 (Rear)

Weight and Dimensions

weight	Approx. 17 Lbs. 3 oz. (8Kg)
measurements	Approx. 17" x 6-1/5" x 12-3/8" (430x157.5x310mm)