Help Guide
Wireless Noise Canceling Stereo Headset
WF-1000XM4
Pairing and connecting with a computer (Windows 10)
The operation to register the device that you wish to connect to is called “pairing”. First, pair a device to use it with the
headset for the first time.
Before starting the operation, make sure of the following:
Your computer has a Bluetooth function that supports music playback connections (A2DP).
The computer is placed within 1 m (3 feet) of the headset.
The headset is charged sufficiently.
The operating instructions of the computer is in hand.
Depending on the computer you are using, the built-in Bluetooth adaptor may need to be turned on. If you do not
know how to turn on the Bluetooth adaptor or are unsure if your computer has a built-in Bluetooth adaptor, refer to
the operating instructions supplied with the computer.
If your OS version is Windows 10 version 1803 or later, the Swift Pair function will make pairing easier. To use the
Swift Pair function, click [Start] button - [Settings] - [Devices] - [Bluetooth & other devices], and check [Show
notifications to connect using Swift Pair].
Remove both units of the headset from the charging case.
The headset turns on automatically.
1
Enter pairing mode on this headset.
When you pair the headset with a device for the first time after purchase or after initializing the headset (if the
headset has no pairing information), the headset enters pairing mode automatically if you remove the headset from
the charging case. In this case, put the headset units into both ears and proceed to step 3.
When you pair a second or subsequent device (if the headset has pairing information for other devices), put the
headset units into both ears, then hold your fingers to the touch sensors on both the left and right units for about 5
2
To Next Page
Need help?
General
Weight and Dimensions
