Hint
The above procedure is an example. For more details, refer to the operating instructions supplied with your iPhone.
If the iPhone was connected with the headset the last time, an HFP/HSP connection is established when you turn on the headset.
Double tap (gently touch it with your finger and immediately release it two times in rapid succession (interval of about 0.4
seconds)) the touch sensor control panel (middle of the right unit) while the headset power is turned on to switch to a music
playback connection (A2DP).
Note
When connecting, either [WH-1000XM3] or [LE_WH-1000XM3] or both are displayed on the connecting device. If both or [WH-
1000XM3] are displayed touch [WH-1000XM3], or touch [LE_WH-1000XM3] if [LE_WH-1000XM3] is displayed.
If the last-connected Bluetooth device is placed near the headset, the headset may connect automatically to the device by simply
turning on the headset. In that case, deactivate the Bluetooth function on the device or turn off the power.
If you cannot connect your iPhone to the headset, delete the headset pairing information on your iPhone and perform the pairing
again. As for the operations on your iPhone, refer to the operating instructions supplied with your iPhone.
Related Topic
How to make a wireless connection to Bluetooth devices
Pairing and connecting with an iPhone
Listening to music from a device via Bluetooth connection
4-740-049-11(3) Copyright 2018 Sony Corporation
Touch [WH-1000XM3].
You will hear a voice guidance “Bluetooth connected”.
4
To Next Page
Loading...
Need help?
General
Weight and Dimensions
