Help Guide
Wireless Noise Canceling Stereo Headset
WH-1000XM3
Making a call
You can enjoy a hands-free call with a smartphone or mobile phone that supports the Bluetooth profile HFP (Hands-free
Profile) or HSP (Headset Profile), via a Bluetooth connection.
If your smartphone or mobile phone supports both HFP and HSP, set it to HFP.
The operation may vary depending on the smartphone or mobile phone. Refer to the operating instructions supplied
with your smartphone or mobile phone.
The headset only supports normal incoming calls. Calling apps for smartphones and computers are not supported.
Connect the headset to a smartphone or mobile phone beforehand.
1
Operate your smartphone or mobile phone to make a call.
When you make a call, the dial tone is heard from the headset.
If you make a call while you are listening to music, playback pauses.
If no dial tone is heard via the headset, switch the call device to the headset using your smartphone or mobile
phone or by holding your finger to the touch sensor control panel until the device is switched.
2
Adjust the volume by operating the touch sensor control panel.
To increase the volume: Swipe up repeatedly until the volume reaches the desired level.
To decrease the volume: Swipe down repeatedly until the volume reaches the desired level.
3
To Next Page
Loading...
Need help?
General
Weight and Dimensions
