EN
2 IDENTIFICATION OF MAIN COMPONENTS
1. IDENTIFICATION OF MAIN COMPONENTS
Do not dispose of electrical equipment together with household waste material. In observance of European Directive
2012/19/UE on waste electrical and electronic e quip ment and its implementation in accordance with national law, electric
equipment that have rea ched the end of their life must be collected se pa rately and returned to an environmentally compat-
ible recycling facility. If electrical appliances are disposed of in landlls or dumps, hazardous substances can leak into the ground-
water and get into the foodchain, damaging your health and well-being. For further information on the disposal of this product,
contact your dealer or a dome s tic waste collection Service.
15
1
7
9
5
4
11
22
10
12
6
C 1.8 ET - SE 1814 Q - SE 2014 Q
C 2.0 ET - SE 2016 Q - C 2.2 ET
SE 2216 Q - XC 120 Q - CP 2.0 Q - A 220 EQ
MAIN COMPONENTS
1. Power unit
2. Spiked bumper
3. Front hand guard
4. Front handgrip
5. Rear handgrip
6. Chain catcher
7. Bar
8. Chain
9. Bar cover
10. Identication plate
11. Power cable
12. Extension lead
(not supplied)
CONTROLS AND FILLING POINTS
13. Trigger switch
14. Safety button
15. Reset button (Only for C 2.2 E/ET
SE 2216 / 2216 Q - A 220 EQ)
16. Extension lead connection
21. Chain oil tank cap
22. Chain oil gauge
IDENTIFICATION PLATE
10.1) Conformity marking in accordance
with Directive 2006/42/EC
10.2) Name and address of the manufacturer
10.3) Acoustic output level LWA in
accordance with directive 2000/14/EC
10.5) Machine model
10.6) Serial number
10.7) Year of manufacture
10.8) Power supply frequency and voltage
10.9) Engine power
10.10) Dual insulation
10.11) Article Code
10.12) Maximum permitted length of the bar.
Do not use longer bars.
The example of the conformity declaration is
found in the penultimate page of the manual.
10.1
10.2 10.3
10.10
10.8
10.9
10.5
10.6
10.7
10.11
10.12
Made in Cina
Electric Chainsaw
V
Hz
W
To Next Page
Loading...
Need help?
General
