• Adhere strictly to the local regulations governing
the disposal of packaging, oil, fuel, lters,
damaged parts or any other element which may
have an impact on the environment; this waste
should not be disposed of along with standard
household waste, but must be disposed of
separately and sent to special waste disposal
facilities for handling and recycling.
• Adhere strictly to local regulations governing the
disposal of cuttings.
• When the machine is withdrawn from service,
do not dump it in the environment, but take it to
a waste disposal facility in accordance with the
local regulations in force.
4 INSURING YOUR LAWNMOWER
Check the insurance on your lawnmower.
Contact your insurance company.
You ought to have fully comprehensive insurance
for trac, re, damage and theft.
5 ASSEMBLY
The battery must be fully charged befo-
Do not use the machine until all the in-
dications provided in the “ASSEMBLY”
section have been carried out.
Unpacking and completing the assem-
surface, with enough space for machi-
ne handling and its packaging, always
making use of suitable equipment.
5.1 ASSEMBLY COMPONENTS (3)
The machine is delivered with the seat, armrests,
steering wheel, tow bar, quick-t supports
dismantled. The battery is in its housing but not
connected.
The packaging holds the components needed for
assembly (3) as listed in the table below:
Pos. No. Description Dimen-
sions
B 2 Pin /
C 2 Shim 6x36
D 1 Shim 16x38x0,5
E 1 Shim 16x38x1,0
Pos. No. Description Dimen-
sions
F 2 Ignition key /
G 2 Screw for battery 8x20
H 2 Nut for battery /
I 4 Nut 8,4x24x1,5
J 1 Tow bar /
K 4 Screw 8x20
L 2 Nut M8
M 2 Nut for battery /
N 2 Screw for battery /
R 2 Split lock washer
14 x 8,2 x 2
5.2 BONNET
Open the bonnet to access the fuel cock,
battery and engine.
The bonnet can be opened as follows:
1. Lift the seat stopper (7:A) and fold the seat
forward.
2. Undo the rubber strap (8:B) on the front edge
of the bonnet.
3. Lift the bonnet (9:C). To close the bonnet lo-
wer it and do up the strap to secure it.
It is prohibited to start the engine when
the bonnet is open.
5.3 BATTERY
For the type of battery installed on the machine,
please refer to “0 TECHNICAL DATA TABLE”
CAUTION! Battery acid is corrosive and
contact with it is harmful.
Handle the battery with care taking care
not to let acid leak out.
5.3.1 Battery connection (5)
Connect the battery to the machine’s electrical sy-
stem using the relative screws and nuts (3:M; 3:N)
1. Connect the red cable to the battery's posi-
tive terminal (+).
2. Connect the black cable to the battery’s ne-
gative terminal (-).
If the leads are disconnected/con-
nected in the wrong order, there is a
risk of a short-circuit and damage to the
battery.
EN
ENGLISH
(Translation of the Original Instructions)
11
To Next Page
Loading...
Need help?
General
