To Next Page

To Previous Page

WORKSHOP MANUAL

T...102/122 - TC...102/122

Map of functional units

A typical situation has the pin (3) xed by a self-lock-

ing nut (4) with two anti-friction washers (5) in be tween

the pin (3) and the support element, and be tween this

and the nut (4).

Since these are joints, the nut must never be tighte-

ned completely but only so much that it can ensure the

free rotational movement of the pin on its axis wi thout,

how ever, creating excessive free play which could re-

sult in the parts concerned becoming mi saligned and

failing to work correctly.

A) Fitting snap rings

One side of the “Benzing” snap rings (1) has a round-

ed edge and the other a sharp edge.

For maximum grip the rounded part needs to be fa-

cing towards the element to be held (2), with the sharp

edges on the outside.

B) Joint pivot pins

There are a large number of pivot pins, usually con-

nected to rods, that need to be able to move in va rious

directions.

PRACTICAL HINTS

Validity

General informations

This chapter covers the main aspects of a servic

ing procedure and the general rules for guaran

teeing a successful service which respects the

safety of the machine.

Stiga T 102 Series User Manual

Questions and Answers: