WORKSHOP MANUAL
T...102/122 - TC...102/122
Map of functional units
Always ret the dust covers (4) of the wheels (1).
Once assembly is completed ...
Adjust the drive engagement.
Ret the collector channel.
Tighten the spring of the stretcher.
Remove the collector channel.
It is advisable to slacken the transmission belt to work
on the parts involved more easily. This is done by
slackening the stretcher.
The small side wheels (1), are xed to the frame by a
nut (2), with a spacer (3) between which is of dier-
ent height, (3a) or (3b), depending on the assembly
po si tion.
When reassembling, you should bear in mind that the
tall spacer (3a) must be tted under the small right
wheel (1a) and the low one (3b) under the left wheel
(1b).
Validity
General informations
Related topics
[
4.3] Drive belt adjustment
[
5.3] Removal of the collector channel
[
8.2] Belts assembly
Tightening torques
2 Nuts for small wheels ..................... 25 ÷ 30 Nm
REPLACEMENT OF THE SMALL WHEELS
FOR THE DRIVE BELT
CHAPTER REVISION FROM ... PAGE
6.5 0 2018 1 of 1
To Next Page
Loading...
Need help?
General
