Stihl FS 100 Instruction Manual

FS 100, FS 100 R
English
33
N Check the grease level regularly –
about every 25 hours of operation.
N Unscrew the filler plug (1). If no
grease can be seen on the inside of
the filler plug, screw the tube (2) of
STIHL gear lubricant (special
accessory) into the filler hole.
N Squeeze up to 5 g grease into the
gearbox.
NOTICE
Do not completely fill the gearbox with
grease.
N Remove the tube of grease (2).
N Refit the filler plug (1) and tighten it
down firmly.
For periods of 3 months or longer
N Drain and clean the fuel tank in a
well ventilated area.
N Dispose of fuel properly in
accordance with local
environmental requirements.
N Run the engine until the carburetor
is dry – this helps prevent the
carburetor diaphragms sticking
together.
N Remove, clean and inspect the
cutting attachment. Coat metal
cutting attachments with corrosion
inhibitor.
N Thoroughly clean the machine.
N Clean the air filter.
N Store the machine in a dry and
secure location – out of the reach of
children and other unauthorized
persons.
N Use a sharpening file (see "Special
Accessories") to sharpen dull
cutting attachments. In case of
more serious wear or nicks:
Resharpen with a grinder or have
the work done by a dealer – STIHL
recommends a STIHL servicing
dealer.
N Sharpen frequently, take away as
little metal as possible – two or three
strokes of the file are usually
enough.
N Resharpen the teeth (1) uniformly –
do not alter the contour of the parent
blade (2) in any way.
See cutting attachment packaging for
additional sharpening instructions. Keep
the packaging for future reference.
Lubricating the Gearbox
1
233BA010 KN
2
Storing the Machine Sharpening Metal Cutting
Blades
2
1
002BA083 KN
2
1
2
2
1
1

Stihl FS 100 Specifications

General

Brand	Stihl
Model	FS 100
Category	Engine
Language	English