Stihl HT 135 Instruction Manual

HT 105, HT 134, HT 135
English
13
Re-tensioning during cutting work:
N Shut off the engine
N Loosen nuts
N Raise the guide bar at the nose
N Use the screwdriver to turn the
screw (1) to the right until the saw
chain rests against the underside of
the guide bar
N Raise the guide bar further and
tighten the nuts securely
N Next step: Continue with "Checking
Chain Tension"
A new saw chain has to be re-tensioned
more often than one that has been in
use for some time.
N Check chain tension frequently –
see chapter on "Operating
Instructions"
N Shut off the engine
N Wear work gloves to protect your
hands
N The saw chain must fit snugly
against the underside of the bar and
it must still be possible to pull the
chain along the guide bar by hand
N If necessary, re-tension the saw
chain
A new saw chain has to be re-tensioned
more often than one that has been in
use for some time.
N Check chain tension frequently –
see chapter on "Operating
Instructions"
It may be necessary to correct the
adjustment of the throttle cable after
assembling the machine or after a
prolonged period of operation.
Adjust the throttle cable only when the
unit is completely and properly
assembled.
N Set the throttle trigger to the full
throttle position.
N Carefully rotate the screw in the
throttle trigger in the direction of the
arrow until you feel initial resistance.
Then rotate it another half turn in the
same direction.
Tensioning the Chain
1
390BA045 KN
Checking Chain Tension
390BA046 KN
Adjusting the Throttle Cable
002BA655 KN

Stihl HT 135 Specifications

General

Brand	Stihl
Model	HT 135
Category	Pole Saw
Language	English