Stihl RE 140 K User Manual

•
Unscrew high-pressure hose (1).
•
Unscrew hose connector (2)
from water inlet.
•
Undo fastening screws (rear
screw not shown).
•
Remove shroud.
Ensure that spring nuts and
power cable are not lost.
Reassemble parts in reverse order.
•
Disconnect detergent intake
hose from metering valve.
- Remove shroud (see 5.1).
- Stand machine upright.
RE 140 K
•
Undo fastening screw on motor /
pump unit, steadying the
machine with the other hand at
thesametime.
•
Lift motor / pump unit out of
frame.
RE 160 K
•
Undo fastening nuts on motor /
pump unit, steadying the bolts at
the same time if necessary.
Hold the machine steady and
ensure that washers are not lost.
- Lay machine in a horizontal
position.
•
Lift motor / pump unit out of
frame. Ensure that rubber
buffers, screws and washers
are not lost.
All models
Reassemble parts in reverse order.
621RA001 BL
1
2
621RA002 BL
621RA084 KN
621RA087 KN
621RA085 KN
621RA086 KN
5. HOUSING
5.1 Removing / fitting the
5.2 Removing / installing
motor / pump unit
621RA005 BL
8 RE 140 K, 160 K

Stihl RE 140 K Specifications

General

Brand	Stihl
Model	RE 140 K
Category	Pressure Washer
Language	English