19
4. Replace the battery so its + terminal faces
the cover side as shown in the illustration.
Lithium disc type battery: CR2025 or equiva-
lent.
Confirm that the O-ring is placed in position
on the body side.
5. Reinstall the cover.
SETTING AND/OR CHANGING THE PASS-
CODE
By setting a 4-digit passcode, the engine can
be started by entering the passcode even if the
key-fob battery has run down or the key-fob is
lost.
The same method is used to set and change
the passcode.
NOTE:
Carry the passcode with the emergency key in
case the key-fob battery runs down or the key-
fob is lost.
NOTE:
When the passcode has been updated or
changed, the previous passcode is deleted and
updated to the new passcode.
Use the following procedure to set or change
the passcode:
1. Confirm that the engine is stopped.
2. Make sure the emergency switch lock plate
is in place.
3. Confirm the key-fob is within the communi-
cation range of the Keyless Start System.
4. Confirm that the key-fob is in communication
ON mode. (Refer to “Switching the commu-
nication mode of the key-fob” section.)
5. Turn the main switch to the “ ” position and
then release it. The main switch automati-
cally returns to the “ ” position.
The buzzer on the engine control side emits
one (1) long sound while the buzzer on the
keyless control unit side emits two (2) short
sounds simultaneously.
To Next Page
Loading...
Need help?
General
