29
BUTTON FUNCTIONS
The multi-function gauge has four buttons:
[MENU], [ ], [ ], and [SET].
The function of each button is as follows.
The [MENU] button gives you access to the
menu screen.
NOTE:
Pressing and holding the [MENU] button can
transfer the mode to the TROLL mode.
Use the [ ] and [ ] buttons to move the
selection cursor, select sub information, and
adjust information input.
NOTE:
Press and hold either the [ ] or [ ] button to
reset the trip time, trip distance, average fuel
consumption, and total fuel consumption in the
sub information simultaneously.
The [SET] button is used to decide the select-
able item.
NOTE:
Pressing and holding the [SET] button, can
change the illumination for the gauge screen to
that for the daytime or nighttime.
Day Night
P
M
P
M
SCREEN SELECTION
The multi-function gauge can select the display
screen from the following choices.
• Engine Speed
• Ground Speed/Fuel Information
• Fuel Information
• All Items Display Screen (Full Item)
To select the display screen:
Press the [SET] button and select the desired
display screen.
Every time the [SET] button is pressed, the dis-
play screen switches in the following sequence.
NOTE:
Screens that had been set to “OFF” in the dis-
play setting are not displayed and the display
skips to the next screen. (Refer to the MENU
INFORMATION SELECTION section)
Engine Speed Display Screen
Screen
Fuel Information Display Screen
All Items Display Screen
Speed/Fuel Information Display
To Next Page
Need help?
General
