70
Speed control
To increase speed after you have shifted into
gear, continue moving the control handle for-
ward or rearward.
STOPPING THE ENGINE
NOTE:
When it is necessary to stop the engine in an
emergency, pull the emergency stop switch lock
plate by pulling the emergency stop switch
cord.
If equipped with Keyless Start System:
To stop the engine:
1. Shift into “NEUTRAL”.
2. After operating at full throttle, cool off the
engine a few minutes by allowing it to idle or
troll at low speed.
3. Push the “START & STOP” switch to stop the
engine.
WARNING
Since the same handle is used for shift-
ing and speed control it is possible to
move the handle past the detent and
engage the throttle. This can cause the
boat to move suddenly resulting in per-
sonal injury or property damage.
You must be careful not to move the con-
trol handle too far forward or rearward
when shifting.
4. Turn the Keyless Start System to OFF
(locked) status by one of the following meth-
ods.
• Make sure that the key-fob is within the
communication range of the keyless con-
trol unit.
Turn the main switch to the “ ” position
and then release it. The main switch auto-
matically returns to the “ ” position.
The buzzer sounds once to notify that the
Keyless Start System has been turned to
OFF (locked) state.
• While the key-fob is within the communi-
cation range of the keyless control unit,
press the lock button 1 on the key-fob.
The buzzer sounds once to notify that the
Keyless Start System has been turned
OFF (locked).
To Next Page
Loading...
Need help?
General
