22
PASSCODE CONFIRMATION
1. Confirm that the engine is stopped.
2. Make sure the emergency switch lock plate
is in place.
3. Confirm the key-fob is within the communi-
cation range of the Keyless Start System.
4. Confirm the key-fob is in ON mode. (Refer to
“Switching the communication mode of the
key-fob” section.)
5. Turn the main switch to the “ ” position and
then release it. The main switch automati-
cally returns to the “ ” position.
The buzzer on the engine control side emits
one (1) long sound while the buzzer on the
keyless control unit side emits two (2) short
sounds simultaneously.
6. Within eight (8) seconds after performing
Step 5, start the following operation.
(1)Turn the main switch to the “ ” position and
hold it for five (5) seconds or longer, then
release it to the “ ” position.
Repeat this operation for two more times.
(2)The LED on the key-fob blinks once and the
buzzer sounds once.
After that, the LED on the key-fob blinks to
indicate the passcode by the number of
blinks, as shown in the illustration.
This is indicated repeatedly.
NOTE:
The passcode indication will not start if Step (1)
is not performed within eight (8) seconds or the
operation fails.
In this case, turn the main switch to the “
”
position and then release it to the “
” position
to turn the Keyless Start System OFF. After
that, retry the procedure from Step 5.
7. After the passcode confirmation is com-
pleted, turn the main switch to the “ ” posi-
tion and then release it. The main switch
automatically returns to the “ ” position.
The Keyless Start System turns OFF and
the passcode indication stops.
Hold it for five (5) seconds.
Example: In the case of passcode 1234
LED
To Next Page
Loading...
Need help?
General
