7-3
PROCEDURE FOR RETURNING
TO SERVICE
1. Clean the entire motorcycle.
2. Remove the oily rags from the
air cleaner intake and muffler
outlet.
3. Drain all the engine oil. Install
a new oil filter and fill the
engine with fresh oil as out-
lined in this manual.
4. Remove the spark plug. Turn
the engine a few times. Rein-
stall the spark plug.
5. Make sure that the motorcycle
is properly lubricated.
6. Perform the INSPECTION
BEFORE RIDING as listed in
this manual.
7. Start the motorcycle as out-
lined in this manual.
If the engine is hard to start, follow
the procedure below:
Due to deterioration of fuel
remaining in the fuel line for long
period, engine will be difficult to
start until the deteriorated (stale)
fuel is discharged from the fuel
line. Repeated kick operation is
required for flushing the fuel line
with fresh fuel.
1. Fill the fuel tank more than half
full.
2. Shift the transmission into neu-
tral.
3. While keeping the throttle
approximately 1/4 open,
repeat kick start operation 30
to 40 times.
NOTE: Fuel injection volume is
controlled to increase in throttle
open condition. However, do not
open throttle more than 1/2 as
fuel injection is shut off in wide
open throttle in engine start
mode.
4. Start the engine by following
cold engine start procedure.
NOTE: If the engine fails to start
after several attempts, spark plug
will be get wet. In this case,
repeat kick start operation 4 to 5
times with throttle fully opened to
dry the spark plug. No fuel is
injected with full throttle opening
in engine start mode.
To Next Page
Loading...
Need help?
General
