6-8
ENGINE RUN TIME RESET
PROCEDURE
1. Disconnect the battery coupler
1 from the cap.
2. Connect a 12 volt battery to
the battery coupler using the
battery wire.
3. After connecting the battery
wire, turn the throttle grip to full
open within 2 seconds, then
maintain this state for 5 to 10
seconds.
4. Fully close the throttle grip for
more than 5 seconds.
5. Disconnect the battery wire.
36890-28H00:
Battery wire (option)
NOTE: In case of TP sensor fail-
ure, no engine run time reset
operation is possible.
To Next Page
Loading...
Need help?
General
