33
H
Rebound Damping Force Adjustment
Adjust the setting of the rebound damping force to
the standard position. To adjust, turn the adjuster
screw
B clockwise until it stops, then turn it counter-
clockwise until 13 clicks are felt.
#
Air Pressure Adjustment
Place a block under the chassis tube to lift the front
wheel off the ground. Remove the air bleed screw
C
and equalize the air pressure in the front forks to
atmospheric pressure. Re-fit the air bleed screw
C.
!
REAR SUSPENSION
Rebound Damping Force Adjustment
Adjust the setting of the rebound damping force to
the standard position. To adjust, turn the adjuster
screw
A clockwise until it stops and then turn it coun-
terclockwise until approximately 11 clicks are felt and
the two punch marks align.
#
Low Speed Compression Damping Force Adjustment
Adjust the setting of the compression damping force
to the standard position. To adjust, turn the adjuster
screw
B clockwise until it stops and then turn it coun-
terclockwise until approximately 7 clicks are felt and
the two punch marks align.
#
Do not force the adjuster screw
B
BB
B past the
stopped position or you may damage the
adjuster.
Be sure to adjust the damping force on both
front forks equally.
NOTE:
The specified front fork air pressure is 0 kPa (0
kgf/cm
2
, 0 psi) for both fork legs.
Do not pump air into the front fork.
Do not force the adjuster screw
A
AA
A past the
stopped position or you may damage the
adjuster.
Do not force the adjuster screw
B
BB
B past the
stopped position or you may damage the
adjuster.
To Next Page
Loading...
Need help?
General
