37
TIRE PRESSURE
Using an accurate air gauge, check the air pressure
of the front and rear tires. The pressure should be as
shown.
COLD INFLATION TIRE PRESSURE
TRANSMISSION OIL
!
Check the transmission oil level.
1. Run the engine for a few minutes and stop it. Wait
5 minutes.
2. Place the motorcycle on the level ground.
Hold the motorcycle vertically.
3. Remove the oil level screw.
4. If the oil level is below the level hole, remove the
oil filler cap and add transmission oil into the filler
hole until the oil reaches the level hole and stop
adding just before oil flows out.
5. Reinstall the filler cap and the oil level screw then
tighten it securely.
Transmission oil capacity:
750 ml (0.8/0.7 US/lmp qt)
A: Oil level screw
B: Oil filler cap
FRONT REAR
70–110 kPa
0.7–1.1 kgf/cm
2
10–16 psi
70–110 kPa
0.7–1.1 kgf/cm
2
10–16 psi
This motorcycle is shipped from factory with
the engine filled with transmission oil.
Be sure to check oil level.
NOTE:
Use a good quality SAE 10W/40 viscosity rat-
ing.
To Next Page
Loading...
Need help?
General
