7-24
INSPECTION AND MAINTENANCE
52RM0-01E
Gear oil change
Since special procedures, materials and
tools are required, ask an authorized
SUZUKI dealer for this job.
Clutch pedal
Fluid control clutch
52RM70020
Check the clutch pedal for smooth opera-
tion and clutch fluid level from time to time.
If clutch dragging is felt with the pedal fully
depressed, have the clutch inspected by
an authorized SUZUKI dealer. If the clutch
fluid level is near “MIN” line, fill it up to
“MAX” line with DOT3 or SAE J1703 brake
fluid.
Continuously Variable
Transaxle (CVT) fluid
Specified fluid
Use a CVT fluid SUZUKI CVT FLUID
GREEN-2.
Fluid level check
You must check the fluid level with the CVT
fluid at normal operating temperature.
To check the fluid level:
1) To warm up the CVT fluid, drive the
vehicle for more than 5 km (3 miles).
2) Then drive for ten more minutes.
CAUTION
After driving the vehicle, the gear oil
temperature may be high enough to
burn you. Wait until the oil filler and
level plug are cool enough to touch
with your bare hands before inspect-
ing gear oil level.
NOTICE
Be sure to use new plug with new gas-
ket to avoid looseness of the plug and
oil leakage.
MIN
MAX
NOTICE
Driving with too much or too little
fluid can damage the transaxle.
NOTICE
Be sure to use the specified CVT
fluid. Using CVT fluid other than
SUZUKI CVT FLUID GREEN-2 may
damage the CVT of your vehicle.
To Next Page
Loading...
Need help?
General
