SystemAir SysAqua 25 User Manual

English
26 SysAqua
13.1.4. FUNCTION OF DSW2 DIP SWITCHES
DIP OFF ON DEFAULT
1
OFF mandatory
2
Not used ON mandatory ON
3
Auto changeover ON Auto changeover OFF ON
4
OFF = Compressors do not stop
after deice
ON = Compressors stop after
deice
ON mandatory
5
Only cold Heat pump
Only cold = OFF
Heat pump = ON
6
Not used R410A ON
7
One coil Two coils
OFF: SysAqua 25/30/35/40/45/55
ON: SysAqua 65/75/90/105/125
8
Not used Not used OFF
13.2. KEYBOARD
Position 0 : OFF mode : pump and frost protection heaters will run if required. Test mode is possible.
Position 1 : ON mode : Test mode is possible.
There are two menu levels :
² Standard parameters that can be modied
² Factory parameters
protected by a password.
The standard parameter menu can be entered by pressing both buttons for 5seconds.
The menu returns to normal mode if you do not press any button for 10s.
The parameters can be scrolled by pressing the button
and then selected by pressing .
After having selected the parameter, it is possible to change the value by using the button
. The value
is scrolled from its minimum to maximum value. To enter the modied value press the button
.
Touche
: To scroll the MENUS horizontally and to display the values of parameters..
Touche
: To scroll the MENUS and SUBMENUS vertically and to increase the numeric value of parameters.
All information is displayed on 4 7-segment displays.
The heat and cool setpoint s can be modied in the standard parameter
menu.
13.2.1. SWITCH SM1
13.3. DISPLAY

SystemAir SysAqua 25 Specifications

General

Brand	SystemAir
Model	SysAqua 25
Category	Heat Pump
Language	English