Operating in P25 trunking mode 59
Service is lost
If access to the trunking system is lost, no longer
appears, the bars in the RSSI symbol disappear , and
the display shows No service.
The radio sounds five beeps to indicate the loss of
service, followed by a repeating double beep. The
double beep continues until service is restored.
Site trunking operation
During normal trunking operation, your radio may roam
between a number of sites, each with its own zone
controller. This behavior is transparent to you, unless
there is a problem with a zone controller. When this
happens, the radio enters ‘site trunking’ mode, and you
will only be able to communicate with users within a
single site.
While in site trunking mode, the display shows Site
Trunking
, and the radio sounds a repeating double
beep. The double beep continues until normal service
is
restored.
When access to the zone controller is available again,
your radio automatically returns to normal multi-site
operation.
Failsoft operation
Your radio may be programmed to enter ‘failsoft’ mode
when service is lost due to failure of a trunking site
controller. For information about failsoft mode, see
“Failsoft mode operation” on page 69.
Talkgroup 1
No service
Menu
Site Trunking
Zone 11
Menu
To Next Page
Loading...
Need help?
General
