Name: Taylor C712
Brand: Taylor
Rating: 5 (1 reviews)

C712 Operator Training -10-

Freezer Door

Step 1 Place the door gaskets into the grooves on the back of the freezer door. Slide the

front bearings over the baffle rods. The flanged edges should be against the door. DO

NOT lubricate the gaskets or bearings.

Step 2 Slide the two o-rings into the grooves on each prime plug. Apply an even coat of

Taylor Lube to the o-rings and shafts.

Step 3 Insert the prime plugs into the holes in the top of the freezer door and push down.

Step 4 To install the freezer door, insert the baffle rods through the beaters in the freezing

cylinders.

With the door seated on the freezer studs, install the handscrews. Use the long

handscrews on the top and the short handscrews on the bottom. Tighten them equally

in a criss-cross pattern to insure the door is snug.

Step 5 Slide the o-rings into the grooves of each standard draw valve. Slide the H-ring and

o-ring into the grooves of the center draw valve. Lubricate the H-ring and o-rings.

Step 6 Lubricate the inside of the freezer door spouts, top and bottom.

Step 7 Insert the draw valves from the bottom until the slot in the draw valves come into view.

Step 8 Slide the fork of the draw handles in the slot of the draw valves, starting from the

right. Slide the pivot pin through each draw handle as they are inserted into the draw

valves.

Step 9 Snap the design caps over the bottom of the door spouts.

Step 10 Slide the drip pans into the holes in the panels.

Step 11 Install the front drip tray and splash shield under the door spouts.

___________________________________________________________________________

Taylor C712 Operator Training

Other manuals for Taylor C712