Taylor C712 Operator Training

C712 Operator Training -22-
Cylinder
Freezing cylinder walls are scored.
Cause: Missing or worn front bearing and beater shoes.
Remedy: Install or replace the front bearing and beater shoes.
Cause: Broken freezer door baffle rod.
Remedy: Replace the freezer door.
Cause: Broken beater pins.
Remedy: Replace the beater assembly.
Cause: The beater assembly is bent.
Remedy: Replace the beater assembly.
Cause: The gear box is out of alignment.
Remedy: Call an authorized service technician.
The drive shaft is stuck in the drive coupling.
Cause: Mix and lubricant collected in drive coupling.
Remedy: Brush clean the shell bearing area regularly.
Cause: Rounded corners of drive shaft, drive coupling, or both.
Remedy: Call an authorized service technician.
Cause: The gear box is out of alignment.
Remedy: Call an authorized service technician.
___________________________________________________________________________
___________________________________________________________________________
___________________________________________________________________________
___________________________________________________________________________
___________________________________________________________________________
___________________________________________________________________________
___________________________________________________________________________
___________________________________________________________________________
___________________________________________________________________________
___________________________________________________________________________
___________________________________________________________________________
___________________________________________________________________________
___________________________________________________________________________

Taylor C712 Specifications

General

Brand	Taylor
Model	C712
Category	Freezer
Language	English