Taylor C712 Operator Training

C712 Operator Training -14-
Pump Reset
The pump reset button protects the pump motor from being “overworked.”
If the pump motor stops working, it will be necessary to press the corresponding reset button on
the rear of the machine.
Inadequate cleaning of the pump drive shaft is a common cause of pump motor overload. Use the
pump drive shaft removal tool to ease the shaft from the assembly position.
___________________________________________________________________________
___________________________________________________________________________
___________________________________________________________________________
___________________________________________________________________________
___________________________________________________________________________
___________________________________________________________________________
___________________________________________________________________________
___________________________________________________________________________
___________________________________________________________________________
___________________________________________________________________________

Taylor C712 Specifications

General

Brand	Taylor
Model	C712
Category	Freezer
Language	English