C712 Operator Training -9-

Assembly

Freezing Cylinder

Step 1 Before installing the beater drive shaft, lubricate the groove on the beater drive shaft.

Step 2 Slide the beater drive shaft boot seal over the small end of the beater drive shaft and

engage into the groove on the shaft.

Step 3 Heavily lubricate the inside portion of the boot seal and also lubricate the flat end of

the boot seal that comes in contact with the rear shell bearing.

Step 4 Apply an even coat of lubricant to the shaft. DO NOT lubricate the hex end.

Note: To ensure the mix does not leak out of the back of the freezing cylinder, the

middle section of the boot seal should be convex or extend out from the seal. If the

middle section of the boot seal is concave or extending into the middle of the seal,

turn the seal inside out.

Step 5 Insert the beater drive shaft through the rear shell bearing in the freezing cylinder and

engage the hex end firmly into the drive coupling.

Step 6 Before installing the beater assembly, check the scraper blades for any nicks or signs

of wear. If any nicks are present, or if the blades are worn, replace both blades. If the

blades are in good condition, install the scraper blade clips over the scraper blades.

Place the rear scraper blade over the rear holding pin on the beater.

Step 7 Holding the rear blade on the beater, slide it into the freezing cylinder halfway. Install

the front scraper blade over the front holding pin.

Step 8 Install the beater shoes.

Step 9 Slide the beater the remainder of the way into the freezing cylinder and over the end

of the drive shaft. The beater should fit snugly but not so tightly that the beater cannot

be turned slightly to engage the drive shaft.

Make sure the beater assembly is in position over the drive shaft. Turn the beater

slightly to be certain that the beater is properly seated. When in position, the beater

will not protrude beyond the front of the freezing cylinder.

Step 10 Repeat these steps for the other side of the machine.

__________________________________________________________________________________

Taylor C712 Operator Training

Other manuals for Taylor C712