Name: Taylor C712
Brand: Taylor
Rating: 5 (1 reviews)

C712 Operator Training -12-

Freezing Cylinder Checklist

1. Replace scraper blades if they are nicked or damaged. Before installing the beater, be certain

that the scraper blades are properly attached.

2. Check the rear shell bearing for signs of wear (excessive mix leakage in the side drip pan) and

be certain it is properly cleaned.

3. Using a brush and cloth towel, keep the rear shell bearing and the female hex drive socket

clean and free of lubricant and mix deposits.

4. Dispose of o-rings and seals if they are worn, torn, or fit too loosely. Replace with new ones.

5. Follow all lubricating procedures as outlined in "Assembly"

6. Check the condenser and filter for accumulation of dirt and lint. A dirty condenser or filter will

reduce the efficiency and capacity of the machine. The condenser should be cleaned monthly

with a soft brush. The filter should be cleaned weekly.

7. On water cooled units, check the water lines for kinks or leaks. Kinks can occur when the

machine is moved back and forth for cleaning or maintenance purposes. Deteriorated or

cracked water lines should be replaced only by an authorized Taylor Technician.

___________________________________________________________________________

Taylor C712 Operator Training

Other manuals for Taylor C712