Other
20
Restoring to the factory settings
You can restore the unit to the factory settings (original settings upon purchase). Performing the following
procedure returns the volume level, noise cancelling level, etc., to the factory settings and deletes the
information for all registered devices. Charge the battery before restoring the unit.
1 While the power is turned off, press and hold [Í/I ( )] for at least 5 seconds until the
power/pairing LED lights alternately in blue and red.
2 While the power/pairing LED is lighting alternately in blue and red, slide and hold the
Multiple functions button towards “+” and at the same time press and hold [Í/I ( )] for
at least 5 seconds.
• The default settings will be restored after the power/pairing LED (blue) blinks fast and the unit turns off.
∫ Attention
• When pairing a device again, delete the registering information (Device: “EAH-F70N”) from the Bluetooth
®
device’s
menu, and register this unit with the Bluetooth
®
device again. (l 10)
Copyright, etc.
The Bluetooth
®
word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of
such marks by Panasonic Corporation is under license.
Other trademarks and trade names are those of their respective owners.
Siri is a trademark of Apple Inc.
Android is a trademark of Google LLC.
LDAC and LDAC logo are trademarks of Sony Corporation.
Qualcomm aptX is a product of Qualcomm Technologies, Inc. and/or its subsidiaries.
Qualcomm is a trademark of Qualcomm Incorporated, registered in the United States and other countries.
aptX is a trademark of Qualcomm Technologies International, Ltd., registered in the United States and other
countries.
Other system names and product names appearing in this document are in general the registered
trademarks or trademarks of the respective developer companies.
Note that the
TM
mark and
®
mark do not appear in this document.
Remove the right ear pad to view certification information. Remove the ear pad by inserting a finger in the
inside of the ear pad as if grabbing it, then pulling out. (1)
Certification information is indicated on the speaker plate portion (A), which becomes visible when the right
ear pad (R side) is removed. (2)
To attach the ear pad, firstly match the positions of the stitching B on the ear pad and the groove C on this
unit. (3)
Next, press the gather of the ear pad into the channel D on this unit. Press in the entire circumference of the
gather, including the firm part, and make sure there is no buckling. (4)
Do not pull the ear pad with force when attaching or removing.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
