Enjoying the sounds
19
RQT5861
Operations
You may need to use 6 channel analogue input for DVD, for
example when you are playing discs recorded with digital signals
this unit cannot decode. These signals include MPEG and high
quality, multi-channel linear PCM with sampling frequencies of
96 and 192 kHz.
Select “DVD” for any other source to take advantage of this unit’s
features.
DVD 6CH INPUT only works when either SPEAKERS A or BI-WIRE
is on and SPEAKERS B is off.
Press [DVD 6CH INPUT].
Each time you press the button:
DVD ,/ DVD 6CH
Input switches automatically to “DVD 6CH” if you press this button
while another source is selected.
When DVD 6CH INPUT is on:
¡You cannot use any of the DSP sound modes.
¡Speaker settings (
\
page 13) are ineffective. (Change the
settings on the DVD player if necessary.)
¡The bi-amp is off (
\
below).
Using DVD 6CH INPUT
To use SPEAKERS B
Use SPEAKERS B if you have connected another set of speakers
to the B terminals.
Sound will be heard in stereo while SPEAKERS B is on.
Press [B].
If you don’t want sound coming from the speakers connected to the
A terminals, press [A] to turn them off.
By using the bi-wiring feature of this unit to connect your speakers
(
\
page 11), you are able to take advantage of two separate
amplifiers for the high frequency and low frequency ranges. This
enables more highly defined sound reproduction of the two ranges
thus producing high quality bi-amp stereo sound.
Ensure “BI-AMP” lights when [BI-WIRE] is
selected.
BI-AMP will turn off and the indicator will go out in the
following cases:
¡If any of the DSP sound modes are turned on.
¡If DVD 6CH INPUT is selected.
¡Before pressing [BI-WIRE], connect speakers designed for bi-
wiring using bi-wiring connection.
¡Do not select [BI-WIRE] if you have connected two sets of
speakers to the A and B speaker terminals.
Note
To enjoy bi-amp sound
B
C
To Next Page
Loading...
Need help?
General
