Technics SA-GX910 User Manual

Ce
eee
Front
Panel
Controls
and
Functions
: (continued)
fae fee eral
=———— |
Amplifier section cosines
7] Parametric EQ system ON/OFF button
(P. EQ SYS)
This button is used to turn the parametric EQ system ON or
OFF.
Fine mode select button (FINE)
This button is used to fine-adjust the center frequency of the
parametric EQ.
Slope changeover button [SLOPE (Q)]
This button is used to increase or decrease the slope of the
parametric EQ curves.
[40| Parametric EQ/tone mode select button
(P.EQ/TONE)
This button is used to select parametric EQ mode or tone
mode.
i] Center frequency select/bass control
(CENTER FREQ/BASS)
This control is used to select the center frequency in the
parametric EQ mode or to adjust the low-frequency sounds in
the tone mode.
faa} Frequency level/treble control
(LEVEL/TREBLE)
This control is used to adjust the frequency level in the
parametric EQ mode or the high-frequency sounds in the tone
mode.
—-12—
[43] Dolby 3 stereo ON/OFF button (3 STEREO)
This button is used to activate the Dolby 3 stereo effect.
44] Surround ON/OFF button (SURROUND)
This button is used to activate the surround effect.
[45] Surround mode select button
(SURROUND MODE)
This button is used to select the desired surround mode.
Delay time adjustment button (DELAY TIME)
[47] Center mode select button (CENTER MODE)
Each time you press this button, the center mode will change
as follows: NORMAL—> PHANTOM— CENTER OFF.
Test signal transmission button (TEST)
When using the center speaker and the rear speakers, press
this button to activate the test signal. Then adjust the volume
balance of the center speaker and rear speakers.
Center speaker level adjustment buttons
(CENTER LEVEL)
These buttons are used to adjust the volume level of the
center speaker.
Rear speaker level adjustment buttons
(REAR LEVEL)
These buttons are used to adjust the volume level of the rear
speakers.

Technics SA-GX910 Specifications

General

Brand	Technics
Model	SA-GX910
Category	Stereo Receiver
Language	English