Technics SA-GX910 User Manual

Front Panel Controls and Functions
Amplifier section
Speaker selectors (SPEAKERS)
These
selectors
are
used
to
select
the
speaker
system(s)
(A
and/or
B).
Display mode select button
(‘DISPLAY MODE -DEMO)
This
button
is
used
to
select
either
the
spectrum
analysis
level
(“Bar-type
display”
or
“Dot
display”)
or
equalization
level
display.
If
the
button
is
pressed
for
3
seconds
or
more,
this unit
will
Start
a
demonstration
mode
for
the
parametric
EQ
system.
(Refer
to
page
25
for
detailed
information.)
25|
Parametric
EQ
band
select
buttons
These
buttons
are
used
to
select
the
band
to
be
adjusted.
Equalization preset buttons
(MANUAL PRESET)
These
buttons
are
used
for
storing
or
recalling
the
curves
made
by
the
parametric
EQ
system.
Tape-monitor switch (TAPE MONITOR)
Press this button to listen to a tape or an audio source con-
nected to the “TAPE” terminals.
To listen to some other source, press this button once again
(so that the indicator is switched OFF).
Volume control (VOLUME)
Headphone jack (PHONES)
=<"
Parametric
EQ
system
memory
button
(MEMORY)
This
button
enabies
the
curves
to
be
stored
in
the
parametric
EQ
system
memory.
1]
Fixed
preset
button
(FIXED
PRESET)
This
button
is
used
to
recall
a
“fixed
preset”
curve
from
the
main
unit’s
memory.
82] Input selector buttons
These
buttons
are
used
to
select
the
sound
source
to
be
heard,
such
as
a
disc,
radio
broadcasts,
etc.
The
selected
sound
source
is
shown
on
the
audio
input
selector/frequency
display.
The
“PHONO”
input
selector
has
two
functions:
when
pressed
momentarily
it
selects
“PHONO”.
when
pressed
and
held
for
about
3
seconds,
it
de-activates
the
muting
function.
[33] Loudness switch (LOUDNESS)
Set
to
the
“ON”
position
(the
loudness
indicator
will
i!-
luminate);
when
listening
to
music
at
low
volume.
Auditory
Perception
of
sound
in
the
low
frequency
range
falls
off
at
low
volume,
but
when
the
switch
is
in
this
position,
this
deficiency
is compensated for, so that the full impact of the musical
performance can be enjoyed.
4] Dolby surround Input balance contro!
(SURROUND INPUT BALANCE)
This control is used to minimize dialogue leakage in the
surround
channel
thereby
optimizing
the
Dotby
surround
decoding operation.
[35] Balance control (BALANCE)
“VCR 3” terminals (VCR 3)
These terminals are used for tape-to-tape recording if a third
VCR is connected here.

Technics SA-GX910 Specifications

General

Brand	Technics
Model	SA-GX910
Category	Stereo Receiver
Language	English