Technics SC-EH600 User Manual

■ wemm
. -j
'mzmm
FM AUTO/MONO
o
□
TUNING
r -1 TUNER/ )
l “ J BANDp. /
-©
j \
j [ Ftl B 7 5Gmhz[J^^|
: ]
TUNING MODE
(When you select "PRESET")
PRESET
CH i
PRESET
Ftl
TUNED
MHzn
* (When you select
: "MANUAL")
MANUAL
TUNED
r-t\
| (When you select "PRESET") *
/ PRESET
1 fllSuHtTl
IVOUllHEJ
\
(When you select
"MANUAL")
\ .
( MRNURL
rfiRafTi
JK
(F P L
FM AUTO/MONO
TUNEDDDNR
... _ NO
Ftl BB IOmhi
MONO |—
/ \ - 1 \ TUNER/BANO
iro
Qoo
oooo
oooo
ISC-EH500i
O O'
ooo
ooo
o
Listening to radio broadcasts
This example in the figure shows how to tune in FM stations.
fl Switch on the power.
Press TUNER/BAND to select the desired band.
Each time you press this button, "FM" and "AM" will appear
alternately.
El Press TUNING MODE to select “PRESET” or
“MANUAL”.
Each time you press this button, "MANUAL" and "PRESET"
will appear alternately.
•Select "PRESET" when stations are preset.
(Refer to "Memory presetting" on pages 13 or 14 to preset
stations.)
• Select "MANUAL" when stations are not preset.
Fl Press TUNING (v or a) to tune In the desired
broadcast.
"STEREO" lights when an FM stereo broadcast is being re¬
ceived.
"TUNED" lights when you precisely tune in a broadcast station.
Automatic scanning (when you select "MANUAL” in
step 0 ):
Press and hold TUNING (v or a ) until the displayed frequency
starts to scroll.
•The scrolling of the displayed frequency will automatically
stop if a broadcast station frequency is located during the
tuning process.
•When there is excessive interference, automatic scanning may
not function.
To cancel automatic scanning, press TUNING ( v or a ) once
again.
p| Adjust the volume level.
Fortuning by remote control (when you select “PRESET”
in step 0 above):
Specify the channel you want with the numeric buttons (see page 53
or 54).
To select a two-digit channel:
Press 510 and then the two numbers you want within 10 seconds or
so.
irons
If an FM station is preset to "MONO", the "STEREO" indicator will
not light up even if a stereo broadcast is being received.
If noise is excessive in the FM stereo mode; Q
Press FM AUTO/MONO.
The sound reception mode switches to "MONO" (monaural) and
"MONO" lights.
The sound will then be heard in monaural. If the broadcast signal is
weak, or if there is a large amount of interference, you will get a
clearer sound using MONO function.
To cancel the "MONO" mode, press the button again.
When “MONO” indicator goes off:
Use this setting for normal listening. Both stereo and monaural
sounds can be heard as they are.
If you change frequencies in the "MONO" mode, the "MONO" mode
will be cancelled.
-One-touch play E-
When the system is OFF, you can receive the station last tuned
in when you press TUNER/BAND on the remote control.
Play will start with volume increasing gradually.
Radio
operations

Technics SC-EH600 Specifications

General

Brand	Technics
Model	SC-EH600
Category	Stereo System
Language	English