Technics SC-EH600 User Manual

Recording
operations
AOPEN a open
3
REV MODE
DECK1/2
o - ►
TAPE EDIT
C
o o o
NOR
O O O
HIGH
Tape-to-tape recording
Preparation
The leader tapes in both decks must be wound up beforehand.
(See page 34.)
H Press INPUT SELECTOR to select “TAPE”.
0 Press A OPEN on the both decks and insert the
tapes.
DECK1: For playback
DECK 2: For recording
Close the holders.
H Press REV MODE to select the reverse mode.
^: Sin gle-sid ed recordin g
Two-sided recording (forward side—>reverse side)
CZZy Same as above (When you press NOR or HIGH, "C^D"
will be automatically switched over to " 7 --," 1
FI Set the tape direction “£>” of deck 1 and 2.
Press DECK 1/2 and confirm both deck's tape directions are
To change the tape direction, first press O, and then ■ .
To record on the reverse side, set deck 2 to
0 Press NOR or HIGH of TAPE EDIT to start re¬
cording.
NOR: When you wish to monitor the sound while recording
HIGH: When you wish to record at high speed (about 2.0 times
normal speed)
While recording, both deck 1 and 2 indicators light up. Tire tape
direction indicator « or » shows deck 2 direction.
If either deck 1 or deck 2 stops, the other deck also stops.
To stop recording:
Press ■ .
Both decks will stop.
To enjoy another source while recording:
Start playing the other sound source.
You can change the volume level and tone quality without affecting
the recording,
Notes
•During high speed recording, turn off TVs or any other image
projecting equipment so as to prevent static from being recorded.
•Tone changes and special effects cannot be recorded.
• The recording level and the noise reduction effect of the original
(playback) tape will be recorded on the new tape.

Technics SC-EH600 Specifications

General

Brand	Technics
Model	SC-EH600
Category	Stereo System
Language	English