Technics SD-5948 User Manual

TAPE MONITOR
STANDB
mnopnnaonas LEELEE E ETTET EETEETTETEETTETTEETTTTETTTTETTTZTYTITTTITT]
SPEAKERS
On
the
amplifier’s
display
$
È=
tottttornvonnonnonngop CHF OEHTOO CECE HE CEH TOP ES RTECS NASER SRECEREEE seececesee
SOPOT OR SO REP Pe OTE OF ETO EEE eRE SEE eS ORCC ROCe Hee Hee heehee neananES
BAND On the tuner’s display
Lif i)
HA ng i 7
PRTHHHRTSOCCOPESRA OPE TOOT E RE SSR ECHR ESE OCC e eee ee eetnu ste BBeEETSaEaEe ESS ,
DIRECT TUNING
NI |
zal . Ryo |
Lights up when an FM stereo broadcast is received
SC Reeseeteouneunenaeee SHPOST OCF ECCS Het ETeBSeE SSR ESae eeseeeeeeeeesresteres
VOLUME
Listening to radio broadcasts
To listen to the radio without presetting stations
Specify the frequency using the numeric buttons to directly tune to
the desired broadcast station.
Press POWER of the amplifier and tuner.
First switch on the power of the amplifier.
The units will switch on.
At power ON, if the “TAPE MONITOR” indicator
flashes on the amplifier display
Press TAPE MONITOR and check the indicator goes out.
Press SPEAKERS to turn on the speaker systems.
Press TUNER.
Press BAND to select “FM” or “AM”.
Press DIRECT TUNING.
OOS ew
(While cursor display is flashing [approx. 10 seconds])
Press the appropriate numeric buttons to enter the
frequency.
If the desired FM frequency is 107.9 MHz
m-oa-
If the frequency has been input correctly, the frequency
display will blink.
1. If no button is pressed while the cursor display is flashing,
the display will return to the frequency which is currently
being received. To re-specify the frequency, repeat the
procedure from step 5.
2. If the frequency has not been input correctly, the frequency
display will blink rapidly. In this case, re-enter the
frequency.
Turn VOLUME to adjust the volume level.
If noise is excessive in the FM stereo mode
Press FM MODE. (The “MONO” indication will lights up.)
The broadcast will be monaural, but noise will be reduced. If the
button is pressed once more, stereo mode will be resumed.
After listening is finished
Be sure to reduce the volume level, and switch the power to the
standby condition by pressing POWER of the amplifier.
The power for the system can thereafter be switched on and to the
standby condition by using the power switch of the amplifier.
(provided that the power cords are connected as on page 6.)
=
=
2
2
wed

Technics SD-5948 Specifications

General

Brand	Technics
Model	SD-5948
Category	Stereo System
Language	English