Technics SD-5948 User Manual

è REC PAUSE
Making a recording
To record selected tracks P
[During recording]
Press DECK 1/2 to select the Deck 1.
Press E
Deck 1 will stop, and Deck 2 will record a 4-second silent
interval and then enter the recording standby mode.
Operate Deck 1 to find the track you wish to
record.
It is also possible to change the playback tape at this time.
Press SYNCHRO START.
Recording will resume.
To cut unwanted parts during recording El
Press @ REC PAUSE during recording.
Deck 2, which was recording, will enter the pause mode, and
Deck 1 will continue playback.
(If you were recording at hi-speed, Deck 1 will change to
normal speed while Deck 2 is on pause, but will return to hi-
speed when you resume recording.)
[When Deck 1 reaches a part you wish to record]
Press either <4 or >, corresponding to the side of
the tape side indicator which is lit.
Deck 2 will resume recording.
e When recording with the recording speed set to hi-speed, noise
interference may be recorded onto the tape if there is a television
set nearby, so make the recording in a location separated from the
television set or switch off the television set during recording.
ə Noise reduction does not work during playback of tape-to-tape
recordings. If the tape was recorded with noise reduction, listen at
low treble. Lower the treble with the amplifier’s treble control
before playback.
To make blank tapes
Switch the amplifier to an input source which is not being used.
Insert the recorded tape into DECK 2.
Press DOLBY NR so that the Dolby NR indicator is off.
Press REVERSE MODE to select reverse mode.
Press @ REC PAUSE.
Press 4 or P , whichever side you want to erase.
To erase both sides of the tape, be sure to press the? button.
To record on the VCR {VCR 1}
You can record audio and video sources on a VCR when this latter
is connected to the “VCR 1” terminals on the amplifier.
Sok enre
1. Switch the amplifier to the input source that you want to record.
Recording from the tape deck is not possible.
2. Begin recording on the VCR (VCR 1) and start the desired
source.
(Refer to the appropriate operating instructions for details.)
Recording BE

Technics SD-5948 Specifications

General

Brand	Technics
Model	SD-5948
Category	Stereo System
Language	English