Technics SX-KN7000 User Manual

3. Use the buttons below the display to assign a
name.
4. Press the OK button.
• The display returns to the SAVE display.
5. Use the FROM SONG buttons to select the
SEQUENCER song number you wish to save.
• The song name to save from is shown below
the FROM SONG button.
6. Use the PANEL HEADER buttons to specify
ON or OFF.
ON:
The sound and volume settings for each
part are saved as data at the beginning of
the file.
OFF:
This data is not saved.
7. Use the 1 MEASURE SPACE buttons to select
ON or OFF.
ON:
A one-measure space is added to the begin-
ning of the file.
OFF:
No space is added.
• When there is various data other than perform-
ance data stored at the beginning of a file, the
start of playback may be delayed. This can be
avoided by set the 1 MEASURE SPACE to ON
to inserting a before the beginning of the per-
formance.
• When set to ON, a space is added each time
a file is saved. Therefore, if you have already
saved a file once with the 1 MEASURE SPACE
set to ON, please set it to OFF each time the
file is subsequently saved.
8. Use the SAVE AS button to select the sound
generator mode (GM/GM2/NX).
9. Press the SAVE button.
• The display looks similar to the following.
10.Select the type of data saving.
AT CURSOR LOCATION:
The song is saved to where the cursor is cur-
rently located (overwrite).
AT A NEW LOCATION:
The song is saved as a newly added data with
the last song number.
• The SAVE operation begins.
• When the operation has been successfully
completed, “COMPLETED!” is shown on the
display.
• If you attempt to save data to a file number in
which data is currently saved, the display
changes to the confirmation display. Press the
YES button to continue the SAVE procedure,
or press the NO button if you wish to cancel
it.
SD card
Part VII SD card
149
QQTG0671

Technics SX-KN7000 Specifications

General

Brand	Technics
Model	SX-KN7000
Category	Electronic Keyboard
Language	English