Technics SX-KN7000 User Manual

PITCH ENVELOPE TOUCH & KEY FOLLOW
Specify how the pitch envelope changes in rela-
tion to note pitch.
1. Use the PAGE buttons to view the 3/3 display.
2. Use the buttons to the left of the display to
select a tone.
3. Use the TOUCH ∧ and ∨ buttons to change
the respective touch settings.
• Use the TIME ∧ and ∨ buttons to specify the
time change depending on touch. Use the
LEVEL ∧ and ∨ buttons to specify the pitch
change level depending on touch.
• At a – setting, the softer the keys are pressed,
the greater the change. At a + setting, the
harder the keys are pressed, the greater the
change.
4. Change the key follow settings for the AT-
TACK (ATK), DECAY (DCY) and RELEASE
(RLS).
• Use the ∧ and ∨ buttons corresponding to the
ENVELOPE KEY FOLLOW attributes to adjust
the settings. Use the CENTER ∧ and ∨ but-
tons to select the center of the bend direction.
Filter Edit
Make major changes to the sound by eliminating specific frequency ranges.
FILTER & EQUALIZER
1. On the SOUND EDIT menu, select FILTER.
• The display looks similar to the following.
2. Use the buttons to the left of the display to
select a tone.
3. Use the MODE button to select the filter mode.
LPF(6)+EQ (low-pass filter + equalizer)
Signals higher than the cut-off frequency are
cut. Normal sounds are softened.
HPF(6)+EQ (high-pass filter + equalizer)
Signals lower than the cut-off frequency are
cut. Normal sounds are sharpened.
LPF24 (low-pass filter 24)
A stronger low-pass filter than LPF+EQ.
HPF24 (high-pass filter 24)
A stronger high-pass filter than HPF+EQ.
BPF (band-pass filter)
Cuts off signals that are not within in the area
between the two specified CUTOFF frequen-
cies.
• For this mode, adjust the settings on the
EQUALIZER/FILTER side as well.
THRU
No filter effect is applied.
Sound Edit
Part X Sound Edit
170
QQTG0671

Technics SX-KN7000 Specifications

General

Brand	Technics
Model	SX-KN7000
Category	Electronic Keyboard
Language	English