Tecsun PL-365 User Manual

TECSUN RADIOS AUSTRALIA
24/9 Powells Road, Brookvale, NSW 2100 Australia
Ph: +61 2 9939 4377
Email: info@tecsunradios.com.au
www.tecsunradios.com.au
15
Turn ON/OFF charging function & exchange battery
consumption display
Press & hold the [ ] key with " " & " "
shows up to activate the consumption display of
rechargeable batteries and the built-in charging system.
Press & hold the [ ] key with " " shows up &
" " disappear to activate the consumption display of
alkaline batteries and turn off the built-in charging function.
Note: This radio is default to use alkaline batteries for
power supply. In case of using rechargeable batteries, you
should switch the radio in rechargeable batteries mode in
order to show the correct power capacity.
SLEEP
flashing
TUNE INTO STATIONS
6
Short press [POWER] button to turn on your radio, then
select your desired band by short pressing the [FM], [MW],
SW [ ] or [ ] button. In case of receiving FM/SW
broadcasting, fully extend the telescopic antenna for a
better reception.
Now, you can tune into your favorite station with any of the
below tuning methods:
Method 1: ETM (Easy Tuning Mode)
The ETM function allows you to tune into stations easily
and temporally store them into the ETM storage; 100
stations for FM/MW & 250 stations for SW.
Note: Scanned stations will not be stored in the regular
450 memories, but will remain in the ETM temporary storage
until next ETM scanning within each band.
HOW TO USE ETM
1. Turn on the radio and select
your desired band by pressing
either the FM, MW or SW
[ ] or [ ] button.
2. Short press the [ETM] button to
enter Easy Tuning Mode.
3. Long press the [ETM] button to
automatically scan all available
stations within the selected band.
4. When the scanning procedure is
completed, turn the [TUNING]
knob to browse through the found
stations.
5. Short press the [VF/VM] button to
exit the ETM mode.
Station
Notes:
FM station: When you are in a different city or country, you
should perform the ETM function again, because this will
not delete any of the stations already within the memory.
Frequency
running
Set the fine tuning step
Turn off the radio,
the current fine tuning step, turn the [TUNING] knob to
adjust.
press and hold the [BFO] button to show
- " " indicates that the fine
tuning step of SSB is 50Hz.
- " " indicates that the fine
tuning step of SSB is 20Hz.
- " " indicates that the fine
tuning step of SSB is 10Hz.
fine tuning step

Tecsun PL-365 Specifications

Frequency Range

FM frequency range	87~108 MHz
Japan FM frequency range	76~108 MHz
EU, USA FM frequency range	87.5~108 MHz
MW frequency range	522~1620 (150~1620) kHz
USA MW frequency range	520~1710 kHz
SW frequency range	1711~29999 kHz

Sensitivity

FM sensitivity (S/N=30dB)	Less than 3μV
MW sensitivity (S/N=26dB)	Less than 1mV/m
LW sensitivity (S/N=26dB)	Less than 10mV/m
SW sensitivity (S/N=26dB)	Less than 30μV
SSB sensitivity (S/N=10dB)	Less than 3μV

Selectivity and Stereo Crosstalk

FM selectivity	＞60 dB
MW selectivity	＞60 dB
LW selectivity	＞60 dB
SW selectivity	＞60 dB
FM Stereo crosstalk	Less than 25 dB

Power and Output

Memory capacity	550
Output power	350 mW
Battery type	UM3 or AA X 3
USB power	5V DC

Speaker and Connectivity

Speaker specifications	Φ40mm, 500mW/16 Ohm
Earphone jack specifications	Φ3.5mm, 8~32 Ohm, Stereo type

Weight and Dimensions

Dimensions	Approx. 53(W) X 159(H) X 26(D) mm
Weight	128g (Batteries not included)