Tektronix 2212 User Manual

Warranted Characteristics
Table B-15: Warranted Characteristics -
Environmental, Safety and Reliability (cont.)
Name
Electrostatic Discharge
Vibration (Operating)
Shock (Non-operating)
Bench Handling Test
Description
Conforms to Tektronix Standard 062-2862-00.
(Withstands discharge of up to 20 kV) •
Meets requirements of MIL-T-288000,
para 4.5.5.3.1.'
Meets requirements of MIL-T-288000,
para 4.5.5.4.1, except limited to 30 g. u
Meets requirements of MIL-T-288000,
para 4.5.5.4.3. h
Tested to MIL-T-28800D, para 4.5.5.1.3 and 4.5.5.1.4, except that in
par 4.5.5.1.3, steps 4 and 5 (10 °C operating test) are performed before step 2
(-55 °C non-operating test).
Equipment shall remain off upon return to room ambient temperature during
step 6. Excessive condensation shall be removed before operating during
step 7.
Maximum operating temperature decreases 1 °C per 1000 feet above 5,000
feet.
5 cycles (120 hours) referenced toMIL-T 28800D para 4.5.5.1.2.2 for type III,
Class 5 instruments.
To meet EMI regulations and specifications, use the specified shielded cable
and metal connector housing with the housing grounded to the cable shield
on the Parallel Printer!Plotter connector.
Test performed with probe containing 500 pF capacitor with 1 kQ resistance
charged to the test voltage.
15 minutes along each of three major axes at a total displacement of 0.015
inch p-p (2.4 g at 55 Hz) with frequency varied from 10 Hz to 55 Hz to 10 Hz in
one minutes sweeps. Hold for 10 minutes at 55 Hz in each of the three major
axes. All major resonances must be above 55 Hz.
30 g, half-sine, 11 ms duration, three shocks per axis each direction, for a total
of 18 shocks.
Edge lifted four inches and allowed to free fall onto a solid wooden bench
surface.
B - 28
Appendix B: Specifications

Tektronix 2212 Specifications

General

Brand	Tektronix
Model	2212
Category	Test Equipment
Language	English