Tektronix 314 Manual

EXT BLANK. Input connector for external crt blank 
ing signal.
TRIGGERING
AC. Rejects d c components and attenuates triggering
signals below about 50 Hz. See NOTE following AC
LF REJ.
AC LF REJ. Rejects d c and attenuates triggering sig 
nals below about 50 kHz. Accepts triggering signals
between 50 kHz and 10 MHz.
NOTE
With AC and AC LF REJ buttons pushed in
(EXT DC), accepts all triggering signals from d c
to 10 MHz.
INT. Obtains triggering signal from vertical deflection
system (CH 1 or CH 2, or both) when button is pushed
in. Obtains triggering signal from EXT TRIG OR
HORIZ INPUT connector (right-side panel) when
button is out.
LEVEL. Selects the amplitude of the signal on which
the sweep is triggered.
Fig. 8. Rear panel.
Fig. 9. Front panel.
REV. A, AUG. 1975
314 Operators
7

Tektronix 314 Specifications

General

Brand	Tektronix
Model	314
Category	Test Equipment
Language	English