Removal and Installation Procedures
Procedures fo
r Internal Modules (Upper) (AWG7000C Series)
Drive-Bay Module
You need a screwdriver with a T-15 Torx tip (items 1 and 2).
Removal. To r
emove the drive-bay module, follow these steps: (See Figure 4-9
on page 4-22.)
1. Remove the handle unit, snaps, cosmetic covers, front-trim unit, EMI covers,
and hard disk assembly.
2. Orient the instrument s o that the bottom is on the work surface.
3. Remove th
e eight screws securing the drive-bay module to the chassis.
4. Disconnect the cables from J101 and J104 on the Power board.
5. Disconnect the cables from J5J1 and J7J1 on the Processor board.
6. Lift the drive-bay module away from the chassis.
Installation. To install, reverse this procedure.
DVD-R
OM Drive
You need a screwdriver with a T-15 Torx tip and a #1 Phillips screwdriver (items
1, 2, and 5).
Remo
val. To remove the DVD-ROM drive, follow these steps: (See Figure 4-9
on page 4-22.)
1. Rem
ove the handle unit, snaps, cosmetic covers, front-trim unit, EMI covers,
hard disk assembly, and drive-bay module.
2. Re
move the two scre ws securing the DVD-ROM bracket to the drive-bay
chassis.
3
.
S
lide the DVD-ROM drive with bracket out from the drive-bay chassis.
4. Remove the four screws securing the DVD-ROM drive to the bracket.
Installation. To install, reverse this procedure.
AWG7000B and AWG7000C Series Service Manual 4–21
To Next Page
Loading...
Need help?
General
