Acquire the Signal
Setting Up a Serial or Parallel Bus
Your oscilloscope can decode and trigger on:
I
2
C and SPI serial buses if the DPO2EMBD application module is installed
CAN and LIN serial buses if the DPO2AUTO application module is installed
RS-232, RS-422, RS-485, and UART serial buses if the DPO2COMP application module is installed
Parallel buses if you are using an MSO2000 series oscilloscope
(Seepage23,Application Module Free Trial.)
Using Buses in Two Steps
To quickly use serial bus triggering:
1. Push B1 or B2 and enter parame ters o f the
bus to trigger on.
You can separately use B1 and B2 to view
two different buses.
92 DPO2000 and MSO2000 Series Oscilloscopes User Manual
To Next Page
Loading...
Need help?
General
