Getting Acquainted with the Oscilloscope
17. Run/Stop. Push to start or stop acquisitions.
18. Single. Push to make a single acquisition.
19. Autoset. Push to automatically set the vertical, horizontal, and trigger
controls for a usable, stable display.
20. Trigger Level. Turn to adjust the trigger level.
Push Level t o Set 50%. Push the Trigger level knob to set the trigger level to
the midpoint of the waveform.
21. Force Trig. Push to force an immediate trigger event.
22. Ver
tical Position. Turn to adjust the vertical position of the corresponding
waveform. Push Fine to make smaller adjustments.
23
.
1,
2, 3, 4 Menu. Push to display or remove the corresponding waveform
from the display and access the vertical menu.
2
4.
V
ertical Scale. Turn to adjust the vertical scale factor of the corresponding
waveform (volts/division).
MSO2000B and DPO2000B Installation and Safety Instructions 29