Tektronix Keithley 2260B Series User Manual

COMMUNICATION INTERFACE
145
Interface Configuration
USB Remote Interface
USB
configuration
PC side
connector
Type A, host
2260B side
connector
Rear panel Type B, slave
Speed
1.1/2.0 (full speed/high speed)
USB Class
CDC (communications device
class)
Steps
1. Connect the USB cable to the rear
panel USB B port.
2. Change the Rear panel-USB (F-22)
setting to USB-CDC (2).
Page 118
Configure GPIB Interface
To use GPIB, the optional GPIB to USB (2260B-GPIB-USB) adapter
must be used. Only one GPIB address can be used at a time.
Configure GPIB
1. Ensure the 2260B is off before proceeding.
2. Connect the USB cable from the rear panel
USB B port on the 2260B to the USB A port on
the GPIB to USB adapter.
3. Connect a GPIB cable from a GPIB controller to
the GPIB port on the adapter.

Tektronix Keithley 2260B Series Specifications

General

Brand	Tektronix
Model	Keithley 2260B Series
Category	Power Supply
Language	English