Analyze Wavefor
morTraceData
Taking Automatic Measurements in the Time Domain
To take an automatic measurement in the time domain:
1. If the instrument is in the frequency domain,
push channel 1.
2. Push Measure .
3. Push Add Measurement.
Add Mea-
surement
Remove
Measure-
ment
Indicators DVM
DC
Waveform
His-
tograms
More
4. Turn the Multipurpose b knob to select the
specific measurement. If needed, then turn
Multipurpose a to select the channel to
measure on.
5. To remove a measurement, push Rem ove
Measurement,turnMultipurpose a to
select the specific measurement, and push
OK Remove Measurement on the side
menu.
Quick Tips
To re
move all measurements, select Remove All Measurements.
A symbol appears instead of the expected numerical measurement if a vertical clipping condition exists. Part o f the
wave
form is above or below the display. To obtain a proper numerical m easurement, turn the vertical scale and position
knobs to make all of the waveform appear in the display.
If the oscilloscope displays a Low Resolution message, increase the record length of the acquisition so that the
oscilloscope has more points from which to calculate the measurement.
124 MDO3000 Series Oscilloscopes User Manual
To Next Page
Loading...
Need help?
General
