Installation
Humidity:
Operating:
5% to 90% relative humidity (% RH) at up to +40°C,
5% to 60% RH abo
ve +40 C up to +55°C,
non-condensing
Non-Operating:
5% to 90% RH (R
elative H umidity) at up to +40 C,
5% to 60% RH above +40°C up to +55°C,
5% to 40% RH above +55 °C up to +71 ° C
non-condens
ing
Altitude:
Operating:
3,000 m (about 9,843 ft)
Non-operating: 12,000 m (39,370 ft)
Acquisition System: 1 M
The maximum input voltage: At the BNC, 300 V
RMS
, Installation Category II. De-rate at 20 dB/decade between 4.5 MHz and
45 MHz, De
-rate 14 db between 45 MHz and 450 MHz. Above 450 MHz, 5 V
RMS
.
Acquisi
tion System: 50 and 75
The maximum input voltage: 5 V
RMS
with a peak at ±20 V. (DF 6.25%).
Dedicat
ed RF Input:
The maximum operating input level:
Average Continuous Power: +20 dBm (0.1 W)
DC maxi
mum before damage: ±40 V
DC
Max “No damage” +33 dBm (2 W) CW
Peak Pulse Power: +45 dBm (32 W)
Peak Pu
lse Power defined as <10 s pulse width, <1% duty cycle, and reference l evel of +10 dBm
CAUTI
ON. To ensure proper cooling, keep the sides and rear of the instrument clear of obstructions. Ventilation clearance
should be at least 51 mm (2 in) on the left side, when looking at the front of the instrument, and on the rear of the instrument
MDO3000 Series Oscilloscop e with a P6316 Digital Probe
Threshold Accuracy: ±(100 mV + 3% of threshold setting after calibration)
Threshold
Range: +25 V to –15 V.
Maximum nondestructive input signal to probe: +30 V to -20 V
Minimum signal swing: 500 mV
peak-to-peak
Input resistance: 101 K
Input ca
pacitance: 8.0 pF typical
Pollution Degree: 2, Indoor use only
6 MDO3000 Series Oscilloscopes User Manual
To Next Page
Loading...
Need help?
General
