c. In e*Scope, press Ctrl-Alt-Shift to open the Clipboard menu.
d. Paste the text into the Clipboard field.
e. Press Ctrl-Alt-Shift to close the browser Clipboard menu
f. Use e*Scope to open the instrument menu to which to paste content and position the cursor in the field where you want to paste
the text.
g. Press Ctrl-V (on real keyboard or from virtual keyboard) to paste the text from the e*Scope browser clipboard to the menu field.
h. Repeat steps 4.b on page 16 through 4.g on page 17 to copy and paste other text from the PC to the instrument.
Connect the oscilloscope to a PC using a USB cable
Use a USB cable to connect the oscilloscope directly to a PC for remote instrument control.
Procedure
1. On the oscilloscope, select Utility > I/O from the menu bar
.
2. Tap USB Device Port.
3. Confirm that the USB Device Port control is On (default setting).
4. Connect a USB cable from the PC to the USB Device port on the rear of the instrument.
5. If using the USB connection to remotely control the oscilloscope using GPIB adapter (TEK-USB-488), set the GPIB Talk/Listen
Address for your configuration (0 - 30).
Cleaning
Use a dry, soft cotton cloth to clean the outside of the unit. If any dirt remains, use a cloth or swab dipped in a 75% isopropyl alcohol
solution. Use a swab to clean narrow spaces around controls and connectors. Do not use any liquid cleaning agents or chemicals that
could damage the touchscreen, case, controls, markings or labels, or possibly infiltrate the case.
Getting started
3 Series Mixed Domain Oscilloscope MDO32 and MDO34 Quick Start Manual 17
To Next Page
Loading...
Need help?
General
