Operating Basics
7. For Windows 200
0systems:
a. When prompted, select the option that tells Windows to d isplay a list
of known drive
rs and click Next.
b. In the next window, select USB Test and Measurement Device. If you do
not see a USB
Test and Measurement Device selection, the OpenChoice
Desktop software is not properly installed.
c. In the next w
indow, click Next to allow Windows to install the driver
for your o scilloscope.
Windows wi
ll install the driver for your oscilloscope.
d. If you do not see the USB Test and Measurement Device in step b, or if
Windows c
annot fi nd the software driver, the software is not properly
installed.
In these
situations, click Cancel to exit the Found New Hardware wizard.
Do NOT allow the wizard to finish.
Unplug
the USB cable from your oscilloscope, and install the software.
Reconnect your oscilloscope to the PC and follow steps 7a, 7b, and 7c.
8. When prompted, click Finish.
9. If Windows asks you to insert a CD, click Cancel.
10. Run the PC Communications software on your PC.
11. If the oscilloscope and PC do not communicate, refer to the PC
Communications online help and documentation.
26 TBS1000 Series Oscilloscopes Installation and Safety Manual
To Next Page
Loading...
Need help?
General
