EasyManuals Logo
Home>Tektronix>Test Equipment>TDS 520D

Tektronix TDS 520D Technical Reference

Tektronix TDS 520D
162 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #89 background imageLoading...
Page #89 background image
Performance Tests
174
TDS 500D, TDS 600C, TDS 700D & TDS 714L Performance Verification and Specifications
H CHECK that the CH 1 Freq readout is within 950 Hz to 1.050 kHz,
inclusive. See Figure 122.
H Enter frequency on test record.
H Press MEASURE; then press the main-menu button Remove
Measrmnt. Press the side-menu Measurement 1.
Figure 122: Measurement of probe compensator frequency
c. Save the probe compensation signal in reference memory:
H Press save/recall WAVEFORM; then press the main-menu button
Save Wfm Ch 1.
H Press the side-menu button To Ref 1 to save the probe compensation
signal in reference 1.
H Disconnect the cable from CH 1 and the clips from the probe
compensation terminals.
H Press MORE; then press the main-menu button Ref 1 to displayed
the stored signal.
H Press CH 1.
d. Hook up the DC standard source:
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

Table of Contents

Other manuals for Tektronix TDS 520D

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Tektronix TDS 520D and is the answer not in the manual?

Tektronix TDS 520D Specifications

General IconGeneral
BrandTektronix
ModelTDS 520D
CategoryTest Equipment
LanguageEnglish

Related product manuals